Filter
Top Products
www.desatech.com
111987-01D 23
REMOVING/REPLACING GLASS
DOOR
-
tion see Replacement Parts,
-
-
Remove the top and bottom louver panels by si-
multaneously pulling both top end spring latches
towards the center of the appliance until they are
disengaged from the locating holes (see Figure 37).
Repeat for bottom spring latches and pull the lou-
vers outward. To install or replace items removed,
simply reverse the procedures above.
FIREPLACE
INSTALLATION
Continued
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced. If
glass is broken, wear gloves and tape the remaining
fragments onto the frame.
1. Remove screen assembly by pushing the rod
either left or right and then down and forward
to remove screen/rod assembly from the re-
box. Set assembly aside.
2. Lift up on latches to unlock. There are two on
top of rebox and two below rebox that hold
glass door in place (see Figure 38).
3. While holding glass door to prevent it from
falling and causing injury, remove the ve
screws from the hinge located on the left side
of door frame assembly (see Figure 38).
4. Remount the new frame at the hinge with ve
new screws before closing door. This will
ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing
the bar under the tab on door and pushing down
and back on latch (see Figure 38).
6.
Replace screen/rod assembly by reversing step 1.
7. Replace louvers by reversing procedure under
Removing Louver Panels.
Figure 37 - Removing Louver Panel
Louver Panel
Spring
Latch
Lock
Unlock
Glass
Frame
Assembly
Screw
Figure 38 - Removing/Replacing Glass
Door
Hinge
Latch
See Cleaning and Maintenance on page 30.