108860
For more information, visit www.desatech.com
For more information, visit www.desatech.com
22
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL32D, BL36D(S), BL36DH(S)
Installing Logs, Lava Rock and Glowing Embers
INSTALLING OPTIONAL BRICK LINER
MODELS BL32D, BL36D(S), BL36DH(S)
WARNING: If fireplace has been running, turn
off and unplug fireplace. Let cool before installing
brick liner.
This brick liner kit is optional. You may purchase brick liner from
your local retailer or see Accessories, page 31.
CAUTION: Always handle brick panels with two
hands. Do not force brick panels into place. Exces-
sive force will break brick panels.
1. Remove top and bottom louvers to allow access to door latches.
2. Remove screen, unlock door latches and open glass door. See
Removing/Replacing Glass Door, steps 1 and 2, page 21.
3. If installing brick liner in new fireplace, go to step 4. If install-
ing brick liner in an existing fireplace, carefully remove logs,
lava rock, and ember material.
4. Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5. Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 38).
6. Install top brick panel ([V]T36 Series only) by resting on the
top of the rear panel. Hold the top brick panel in place and in-
stall left side brick panel by sliding it between the grate and the
side of the firebox, securing top panel (see Figure 39).
7. Install the right brick panel using the same method described
8. Replace deflector shield using screws removed in step 4.
9. Follow instructions on page 23 to install logs, lava rock, and
ember material.
10. Close glass door, lock latches on top and bottom of door and
replace screen (see Removing/Replacing Glass Door, steps 5
and 6, page 21).
11. Close top and bottom louvers.
Figure 38 - Installing Rear Brick Panel
Figure 39 - Installing Left Side and Top Brick Panels
Rear Brick Panel
Left Side
Brick Panel
Top Brick
Panel (T36
Series Only)
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Note:
36" models shown. Logs will vary slightly for 32" models.
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door.
See Removing/Replacing Glass Door, steps 1 and 2, pages 21 and 22.
Install logs according to instructions for fireplace model numbers.
1. Place log #1 (rear log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 40).
2. Rest log #2 (front log) on the pins on the front part of the grate (see
Figure 41).
1
2
Figure 40 - Installing Log No. 1 Figure 41 - Installing Log No. 2