Desa VSGF36PTB Indoor Fireplace User Manual


 
www.desatech.com
119305-01A
22
OPERATING FIREPLACE
Continued
WARNING: Make sure the se-

when you are away from home for

come on automatically with selec-

Figure 30 - Pilot
(Propane/LP)
Pilot
Burner
Figure 29 - Pilot
(Natural)
Pilot
Burner
Ignitor
Electrode
Ignitor
Electrode
TO TURN OFF GAS


1. Turn control knob clockwise to the
OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set
selector switch in the OFF position to keep
from draining battery.

You may shut off the burners and keep the pilot
lit by doing one of the following:
Turn control knob clockwise to the
PILOT position.
Use remote control manual OFF button.
Set selector switch in the OFF position.
MANUAL LIGHTING

1. Follow steps 1 through 6 under Lighting
Instructions, page 21.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions, page 21.
BLOWER




-




Locate the blower switch by opening lower
louver on replace. Blower switch is located at
lower left inside louver door.
Note: It is safe to operate replace with blower
turned off. However, the blower helps distribute
heated air from the replace.
Note: Periodically check the louvers of the
rebox and remove any dust, dirt or other
obstructions.


Note: All remote control accessories must be
purchased separately (see Accessories, pages
31). Follow instructions included with the re-
mote control.

    -
   Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust ame adjustment knob anywhere
between HI and LO. Slide the selector switch to
the REMOTE position (see Figure 31, page 23).
Note: The burner may light if hand-held remote
was on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.