Desa VSGF36NTB Indoor Fireplace User Manual


  Open as PDF
of 40
 
www.desatech.com
119305-01A
15
Note: If adding the G8007 series brick liner acces-
sory, install it now. Follow instructions in G8007
accessory kit.
     
    


3. Route gas line (provided by installer) from
equipment shutoff valve to replace. Route
exible gas supply line through one of the
access holes.
   
    



-


4. Attach the exible gas line to gas supply (see
Figure 17). Check tightness of exible gas
line attached to gas regulator of replace (see
Figure 17).
5. Check all gas connections for leaks. See
Checking Gas Connections, page 16.
6. Replace log base assembly back into replace.
Feed exible gas line into replace base area
while replacing log base assembly. Make sure
the entire exible gas line is in replace base
area. Reattach log base assembly to replace
with screws removed in step 2.
INSTALLATION
Continued
Figure 16 - Removing Log Base
Assembly From Fireplace
Figure 17 - Attaching Flexible Gas Lines
Together
Flexible Gas Line
from Fireplace
Gas Regulator
To Fireplace
Gas Regulator
Equipment
Shutoff Valve
Provided by
Installer

To External
Regulator
Natural Gas
To Gas Meter
    


We recommend that you install a sediment trap in
supply line as shown in Figure 15, page 14. Locate
sediment trap where it is within reach for clean-
ing. Install in piping system between fuel supply
and replace. Locate sediment trap where trapped
matter is not likely to freeze. A sediment trap traps
moisture and contaminants. This keeps them from
going into replace gas controls. If sediment trap
is not installed or is installed wrong, replace may
not run properly.


Installation Items Needed
• 5/16" hex socket wrench or nut-driver
• Phillips screwdriver
• sealant (resistant to propane/LP gas, not pro-
vided)
1. Remove replace screen. Remove one screw
that holds replace screen in place for ship-
ping. This screw is located near top left side
of screen. Discard screw. Lift replace screen
up and pull out to remove.
2. Remove screws that attach log base assembly
to replace (see Figure 16). Carefully lift up
log base assembly and remove from replace
(see Figure 16).
 previous next