Filter
Top Products
13
104416
OWNER’S MANUAL
4
4
INSTALLING LOGS
Figure 16- Installing Front Log (#1)
Figure 17 - Installing Middle Log (#2)
Figure 18 - Installing Rear Log (#3)
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in prop-
erty damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Place front log (#1) on top of the grate.
Make sure the notches in the bottom of
the log fits over the grate prongs (see
Figure 16). Push back of log flush with
metal grate bar.
2. Rest middle log (#2) behind metal posts
on front burner. Make sure the grooves
in the bottom of the log fit over the
grate. Bring the log forward next to the
metal posts. The cutout on the middle
log must be on top (see Figure 17).
3. Slide the grooves in the back of the rear
log (#3) against the rear grate prongs.
Make sure the peg on the log is on top
(see Figure 18).
4. Place the crossover log (#4) on the back
log and the middle log. Make sure the
peg on the rear log is in the hole in the
bottom of the crossover log. The cross-
over log should fit in the cutout of the
middle log (see Figure 19).
Middle Log (#2)
Metal Post
Groove
Groove
Grate
Grate
Prongs
Metal Grate Bar
Notch
Front Log
(#1)
Rear Log (#3)
Peg
Grate
Prong
Grate
Prong
Rear
Burner
Groove
in Back
of Log
Groove
in Back
of Log
Figure 19 - Installing Crossover Log (#4)
Crossover
Log (#4)
Hole
Peg
Cutout
INSTALLATION
Continued