Filter
Top Products
www.desatech.com
119162-01C22
OPERATING HEATER
Continued
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by pressing
the TEMP + or - buttons.
4. Press the POWER and LOCK buttons together
to turn off the replace
Note: Do not leave the hand-held remote in the
AUTO mode close to the replace. The radiant
heat from the replace will turn off the replace.
Ideally, place the hand-held remote in the center
of the room facing towards the replace.
Note: Do not hold the hand-held remote for a long
time. Body temperature will affect its operation in
the AUTO mode.
Safety Features
When away from home for an extended period
of time or as a child safety feature to prevent
accidental ignition of the replace, the receiver
ON/OFF/REMOTE switch should be in the OFF
position.
Auto Shutoff Feature
1. If the average room temperature exceeds 82°
Fahrenheit (28° Centigrade), the hand-held
remote control will perform a safety override
and shut the replace off. This feature is not
available in the MANU mode.
2. The receiver continuously receives signals
from the hand-held remote to control the
room temperature. If the hand-held remote is
misplaced, obstructed or for any reason cannot
transmit to the receiver, the receiver will shut
off the replace after 8 minutes.
Figure 34 - Thermostat Hand-Held
Remote Control Unit
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases
or Decreases Room
Temperature in
AUTO Mode
Digital Display Shows
Temperature and Settings
Hold the control button on the hand-held remote
until burner turns on. Hold the control button again
until burner turns off (see Figure 33).
TO LOCK press both buttons on hand-held re-
mote control until light stops ashing. Hand-held
remote control is now locked. If the re is on it
will be turned off automatically. In the locked
state, the light will not light up when any button
is pressed.
TO UNLOCK press both buttons together on
hand-held remote control until the light stops ash-
ing. The hand-held remote is now unlocked.
Figure 32 - Control Knob, Ignitor Button
and Remote Selector Switch
Figure 33 - On/Off Hand-Held Remote
Control Unit
Control
Button
Indicator
Light
Selector
Switch
Control
Knob in OFF
Position
Flame
Adjustment
Knob
Ignitor
The hand-held remote can be operated using
either the manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 34). To select Fahren-
heit/Centigrade mode display, carefully press the
˚C/˚F mode button with the end of a paper clip or
similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2.
Press the MANU button to turn on the replace.
3. Press the POWER and LOCK buttons together
to turn off the replace.