Filter
Top Products
OWNER’S MANUAL
9
105331
IGNITOR
1. Remove motor and fan guard from
heater (see Motor, page 8, steps 1
through 5).
2. Remove black ignitor wire from piezo
ignitor. Access ignitor wire through un-
derside of heater base (see Figure 17).
Push wire up through bushing in heater
shell.
3. Remove ignitor mounting screw from
rear head using nut-driver or standard
screwdriver (see Figure 18).
4. Remove ignitor from rear head.
5. Install new ignitor. Attach ignitor to rear
head with ignitor mounting screw.
6. Run ignitor wire from new ignitor
through bushing in heater shell. Attach
ignitor wire to piezo ignitor.
7. Set gap between ignitor electrode and
target plate to .17" (see Figure 19).
Figure 14 - Removing Motor and Fan
Guard from Heater
Figure 16 - Replacing Motor and Fan
Guard into Heater
SERVICE
PROCEDURES
Continued
FAN
1. Remove three screws that attach fan
guard to heater shell.
2. Remove motor and fan guard from
heater shell (see Figure 14).
3. Use hex wrench to loosen set screw that
holds fan to motor shaft (see Figure 15).
4. Remove fan. Be careful not to damage
the fan blade pitch.
5a. If replacing fan, remove old fan and
discard. Go to step 7 below.
5b. If cleaning fan,use soft cloth moistened
with kerosene or solvent.
6. Dry fan thoroughly.
7. Place fan onto motor shaft. Make sure
set screw contacts flat surface on mo-
tor shaft. Tighten set screw firmly (40-
50 inch-pounds).
8. Place motor and fan guard into rear of
heater shell. Make sure power cord is
properly located (see Figure 16).
9. Insert three screws through heater shell
and into fan guard. Tighten screws
firmly.
Figure 15 - Setscrew Location
Setscrew
Rear
Head
Figure 18 - Removing Ignitor Mounting
Screw and Ignitor
Figure 17 - Removing Ignitor Wire from
Piezo Ignitor
Bushing
Piezo
Ignitor
Underside of Heater Base
Ignitor Wire
Ignitor
Target Plate
Gap
Area
Figure 19 - Clearance between Ignitor
Electrode and Target Plate
Ignitor
Electrode
Ignitor
Mounting
Screw
WARNING: Make sure heater
is disconnected from propane
supply. Heater could ignite caus-
ing severe burns.
8. Test for spark. Push piezo ignitor but-
ton and watch for spark between igni-
tor electrode and target plate.
9. Place motor and fan guard into rear of
heater shell (see Motor, page 8, steps 9
through 10).