Filter
Top Products
3
104193
OWNER’S MANUAL
Figure 1 - Portable Forced Air Heater
PRODUCT
IDENTIFICATION
ASSEMBLY
These models are furnished with wheels and
a front handle. Some models are furnished
with a rear handle also. Wheels, handle(s),
and the mounting hardware are found in the
shipping carton.
TOOLS NEEDED
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame.
Install wheels on axle.
IMPORTANT:
When installing wheels,
point extended hub of wheels toward
wheel support frame (see Figure 2).
2. Place cap nuts on axle ends. Gently tap
with hammer to secure.
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater is
over wheels. Line up holes on fuel tank
flange with holes on wheel support frame.
4. Place front handle (and rear handle if pro-
vided) on top of fuel tank flange. Insert
screws through handle(s), fuel tank flange,
and wheel support frame. Attach nut
finger tight after each screw is inserted.
5. After all screws are inserted, tighten
nuts firmly.
Figure 2 - Wheel and Handle Assembly
Lower
Shell
Hot Air
Outlet
Fan Guard
Fuel Tank
Side Cover
Fuel
Cap
Upper Shell
Power Cord
Ignition Control
Assembly (assembly on
inside of side cover)
Thermostat Knob
Front
Handle
Wheel
Support
Frame
Wheel
Hot Air
Outlet
Fuel
Tank
Flange
Screw
Nut
Cap Nut
Rear
Handle
Extended Hub
Axle
Air Inlet