Filter
Top Products
Parts included with this kit:
Part No. Description Quantity
114418-01 Instruction Sheet 1
108085-02 Pilot Orifice LP (30) 1
104506-20 Pan Burner Orifice LP (117, #56) 1
14544 Tube Burner Orifice LP (104, #59) 1
14488 Gas Valve Regulator LP 1
114355-39 Conversion Label, English 1
114356-39 Conversion Label, French 1
56060 Conversion Information Label 1
106739-01 Registration, Gas Conversion 1
Tools Required
• 7/8" Open End Wrench
or Adjustable Wrench
• 3/4" Open End Wrench
or Adjustable Wrench
• 11/16" Open End Wrench
or Adjustable Wrench
CONVERTING FROM NATURAL GAS TO PROPANE/LP GAS
For Use When Converting Model (V)V36N(-B)(C1) Series and CHDV36NR-C Series
This conversion kit must be installed by a qualified
service agency.
Read these instructions completely before installing this conversion kit.
Before proceeding, make sure the gas control valve is in the OFF
position, all electrical power to the appliance is off, and the fireplace
is cool to the touch.
CAUTION: The gas supply shall be shut off prior to
disconnecting the electrical power before proceed-
ing with the conversion.
INSTALLATION INSTRUCTIONS
FOR PCDM-36VB CONVERSION KIT
Save this manual for future reference.
Save this manual for future reference.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
• Torx T20 or Slotted Screwdriver
• 5/32" Allen Wrench
• #2 Short Phillips Screwdriver
• Thread Sealant
(Resistant to Propane/LP)
Removing Louver Panels
Remove the top and bottom louver panels by simultaneously pulling
both top end spring latches towards the center of the appliance until
they are disengaged from the locating holes (see Figure 1). Repeat
for bottom spring latches and pull the louvers outward. To install or
replace items removed, simply reverse the procedures above.
Figure 1 - Removing Louver Panel
Louver Panel
Spring Latch
ACCESSING FIREPLACE
The gas control valve and burner orifices are located under the firebox
floor of the appliance and are accessed by removing the lower louver
panel. The pilot orifice is located in the pilot burner and is accessed
by opening the glass door and removing the logs.
Lock
Unlock
Glass
Door
Figure 2 - Opening Glass Door
Latch
Opening Glass Door
1. Remove screen assembly by pushing the rod either left or right
and then down and forward. Set assembly aside.
2. Lift up on latches of door to unlock. There are two on top of
firebox and two below firebox that hold glass door in place (see
Figure 2).
3. Remove log set from firebox. Refer to Installing Logs, Lava
Rock and Glowing Embers in owner’s manual.