Filter
Top Products
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
Manufactured
Fireplace
Figure 13 - Installing Hood Into Opening
of Manufactured Fireplace
4. Remove mounting brackets and drill a 1/8 inch
diameter hole into fireplace housing at each
marked location.
5. Use the sheet metal screws provided to fasten
brackets to fireplace housing (see Figure 12,
page 3).
6. Slide hood over mounting brackets (see
Figure 12, page 3).
Installing Into Manufactured Fireplace
Opening
1. Discard the mounting brackets.
2. Place the hood inside the fireplace opening as
shown in Figure 13.
3. Hold the hood in place and drill four holes
through hood and into channel on the fireplace
opening (see Figures 14). Make sure holes are
evenly spaced and cover most of the hoodʼs
length.
4. Use the sheet metal screws provided to fasten
the hood to the fireplace opening.
Manufactured Fireplace
Fireplace
Opening
Approximate Screw
Locations
Figure 14 - Screw Placement
Fireplace
Cross
Section
Fireplace
Opening
Fireplace
Hood
Manufactured
Fireplace
OPERATING FIREPLACE WITH
FIREPLACE HOOD
WARNING: Fireplace hood
becomes very hot during fire-
place operation. Do not touch
fireplace hood. Severe burns
could occur.
IMPORTANT: Remove all tape used when install-
ing fireplace hood before operating fireplace.
If you have any questions, contact DESA at 1-866-672-6040.
Fireplace
Opening