Filter
Top Products
www.desatech.com
15113183-01A
ADDING LAVA ROCK
Place lava rock around base of heater if desired.
Be sure not to cover the control knobs or air inlet
openings on the front of heater.
INSTALLATION
Continued
Figure 18 - Installing Middle Log #1, Front
Log #2, Left Log #3 and Right Log #4
Figure 19 - Installing Rear Log #5 and
Crossover Log #6
Left Log #3
Right
Log #4
Front
Log #2
1. Place middle log (#1) onto log alignment
screw located near the center of base, and in
place over log support bracket as shown in
Figures 17 and 18.
2. Place front log (#2) onto base. Position log
onto two alignment screws to the front of base
(see Figure 18).
3.
Place left side log (#3) onto two log alignment
screws on left side of base (see Figure 18).
4.
Place right side log (#4) onto two log alignment
screws on right side of base (see Figure 18).
5. Place rear log (#5) onto two alignment screws
to the rear of base (see
Figures 17 and
19).
6. Place crossover log (#6) onto log alignment
pin on middle log (#1) and rear log (#5) (see
Figure 19).
Figure 20 - Attaching Grate to Base
Assembly
Grate
Slots in Base
ATTACHING GRATE TO BASE
ASSEMBLY
Locate the two slots in the front of the base as-
sembly. Carefully slide the decorative grate into
these slots (see Figure 20).
Figure 17 - Log Alignment Screws
Front Log
Left Log
Right
Log
Rear Log
Middle
Log
Log Support
Bracket
Front
Log
Rear
Log #5
Middle
Log #1
Crossover
Log #6