Filter
Top Products
4
103807
PRODUCT
IDENTIFICATION
UNPACKING
1. Remove all protective packing applied to heater for shipment.
2. Remove heater from shipping container.
3. Check heater for any shipping damage. If heater is damaged, promptly inform
dealer where you bought heater.
ASSEMBLY
This model is furnished with wheels and front and rear handles. Wheels, handles,
and mounting hardware are found in the shipping carton.
TOOLS NEEDED
• Pliers
• Two - 7/16" Open or Adjustable Wrenches
1. Slide axle through wheel support frame. Install wheel spacer and then one flat
washer on each end of axle.
2. Install wheels on axle.
IMPORTANT:
When installing wheels, point exetended hub of wheels toward
wheel support frame (see Figure 2, page 5).
3. Slide one flat washer on each axle end in front of wheel.
4. Install cotter pins through holes at each end of axle. Bend cotter pins with pliers
to secure.
5. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is
over wheels. Line up holes on fuel tank flange with holes on wheel support
frame.
6. Place front and rear handles on top of fuel tank flange. Insert screws through
handles, fuel tank flange, and wheel support frame. Attach nut finger tight after
inserting each screw.
7. After inserting all screws, tighten nuts firmly.
Upper Shell
Hot Air Outlet
Lower Shell
Fuel Cap
Thermostat
Fuel Tank
Power Cord
Motor and
Pump
Assembly
Burner Control
Reset Button
Figure 1 - B350CEA Btu/Hr Model