Filter
Top Products
6
104163
PROPANE CONSTRUCTION HEATER
30,000 BTU/Hr
STORAGE
1. Store propane tank(s) in safe manner.
See Chapter 5 of Standard for Storage
and Handling of Liquefied Petroleum
Gases, ANSI/NFPA 58. Follow all lo-
cal codes. Always store propane tanks
outdoors.
2. Place plastic cover caps over brass
fittings on inlet connector and hose/
regulator assembly.
3. Store in dry, clean, and safe place. Do
not store hose/regulator assembly in-
side heater combustion chamber.
4. When taking heater out of storage, al-
ways check inside of heater. Insects and
small animals may place foreign ob-
jects in heater. Remove motor and other
internal parts if needed to remove for-
eign objects (see Service Procedures,
page 8).
MAINTENANCE
CAUTION: Disconnect heater
from propane supply tank(s).
WARNINGS
• Never service heater while it is
plugged in, connected to pro-
pane supply, operating, or hot.
Severe burns and electrical
shock can occur.
• Keep heater clear and free from
combustible materials, gaso-
line, and other flammable va-
pors and liquids.
• Do not block the flow of com-
bustion or ventilation air.
1. Keep heater clean. Clean heater annu-
ally or as needed to remove dust and
debris. If heater is dirty or dusty, clean
heater with a damp cloth. Use house-
hold cleaners on difficult spots.
2. Inspect heater before each use. Check
connections for leaks. Apply mixture
of liquid soap and water to connections.
Bubbles forming show a leak. Correct
all leaks at once.
3. Inspect hose/regulator assembly be-
fore each use. If hose is highly worn
or cut, replace with hose specified by
manufacturer.
SPECIFICATIONS
Output Rating (BTU/Hr) 30,000
Fuel Propane Vapor Only
Fuel Consumption
Gallons/Hour .33
Pounds/Hour 1.4
Supply Pressure To Regulator
Minimum (for purposes 20 psi
of input adjustment)
Maximum Tank Pressure or 200 psi
Regulator Outlet Pressure 10 PSI
Manifold Pressure 10.1 PSI
Hot Air Output
(CFM Approx) 175
Motor 3045 RPM
Electric Input 120 volt/60 hertz
Amperage .6
Ignition Manual, Piezo
Weight (Pounds)
Heater 9
Shipping 9.5
Size - L x W x H (Inches)
Heater 18.5 x 7.7 x 12.8
Temperature Range for Heater Operation -20° F to 85° F*
* When running heater in temperatures above 85° F, high internal temperatures may cause
thermal limit device to shut down heater.
4. Have heater inspected yearly by a quali-
fied service agency.
5. Keep inside of heater free from com-
bustible and foreign objects. Remove
motor and other internal parts if needed
to clean inside of heater (see Service
Procedures, page 8).
6. Clean fan blades each season or as
needed (see Fan, page 9).