Delta 78-907) Pet Fence User Manual


 
INTRODUCTION
The 50 capacity (model 78-904) and 30 capacity (model 78-907) Biesemeyer
T-Square
Commercial fence systems are specially designed to be used with:
Delt a 10 T ilting Arbor Unisaws
Delt a 10 T ilting Arbor Saws
Delt a 10 Contractor s
Saws
Delt a 10 Contractor s
Saws II
The T-Square
Commercial Fence Systems include the fence assembly, front rail, rear rail and
front guide tube. The accessory right extension table (78-925 for 50 cap acity model and 78-927
for 30 cap acity model) must be ordered separately or a similar extension t able must be con-
structed by following instructions in this manual. The accessory leg kit (model 78-952), used
to support the extension table, must also be ordered separately. IMPORTANT:The T-Square
Fence System is designed to be used O N LY with a supporting extension table.
The following instructions illustrate assembling the T-Square
Commercial Fence System to a
Delt a 10 Tilting Arbor Unisaw
. Instructions for assembling the fence system to Delta 10 Tilting
Arbor Saws and 10 Contractor s
Saws are identical unless otherwise noted.
UN PACKING
Carefully unpack the T-Square
fence system from the shipping carton(s). Figure 2 illustrates all
the items supplied with the 78-904 and 78-907 fence system.
1 - Rear Rail
2 - Front Rail
3 - Guide Tube
4 - T-Square
Fence Assembly
5 - Switch Adapter for Unisaws
6 - Switch Adapter for Contractor s
Saws
7 - Cable Strap
8 - Template for aligning front rail to saw t able
for fastening front and rear rails to
right extension table
9 - 1-1/2 long flat head Phillip s screws (14)
10 - 1-1/4 O.D. Flat Washers (14)
11 - 1/4-20 hex nut s (14)
for fastening rear rail to saw table and sheet metal
extension wing if applicable
12 - 3/8-24 x 1-1/4 long hex head cap screws (3)
13 - 7/8 O.D. flat washers (3)
14 - Lock washers (3)
15 - 3/8-24 hex nut s (3)
for fastening front rail to saw table and sheet metal
extension wing if applicable
16 - 3/8-16 x 1-1/4 long flat head Phillip s screws (3)
17 - 7/8 O.D. flat washers (3)
18 - Lock washers (3)
19 - 3/8-16 hex nut s (3)
for fastening guide tube to front rail
20 - 1/2 long hex screws (7)
21 - Lock washers (7)
for fastening on-off switch adapter to guide tube where
applicable on Unisaws
or Contractors
Saws
22 - 3/4 long hex head screws (2)
23 - Lock washers (2)
for fastening on-off switch to switch adapter where
applicable on Contractor s
Saws
24 - 3/8-16 x 1 long hex head screw (1)
25 - 7/8 O.D. Flat washer (1)
27 - Hex nut (1)