Filter
Top Products
1. LOCATION
Place heater on the floor beneath the coldest window in the room, or any other location. Your heater will reduce the effect
of cold drafts. The heater should not be placed immediately below a power outlet. Do not use this radiator in rooms with a
floor area of less than 43 square feet (4 sq. m.).
2. CONNECTION
The radiator should be connected to a properly polarized A/C 110/120 V household outlet in good condition. Keep loose
clothing or bedding, furniture and flammable material away from the heater’s wall outlet.
3. TURNING ON
Insert the plug into an electrical outlet, rotate the thermostat slider (if provided) to maximum and turn the unit on as fol-
lows using the power selector:
• Turn the power selector to position 1 to select minimum output (the light comes on).
• Turn the power selector to position 2 to select medium output (the light comes on).
• Turn the power selector to position 3 to select maximum output (the light comes on).
4. WATTS ECONOMIZER
For more efficient operation, use power setting 1 or 2 after your desired temperature has been reached.
Adjusting the thermostat
When the room has reached the desired temperature, turn the thermostat slider slowly in a clockwise direction, stopping
when you hear a click sound. The unit will maintain the set temperature and conserve energy by cycling on and off.
If your unit has three power settings, on days when temperatures are not particularly cold, select minimum output to opti-
mize efficiency and energy savings.
Antifreeze function
Turn the thermostat dial to the and select the maximum power. The appliance will maintain a minimum room tempe-
rature of approximately 42°F (5°C), thus preventing freezing temperatures while conserving energy. In models that come
with a timer, tabs must be set in the inward position.
REMINDER
To completely shut the appliance off, turn the power selector to the 0 position and then unplug the appliance from the
outlet.
5. TIMER (ON SELECTED MODELS)
ABOUT THE TIMER The programmable clock timer allows you to preprogram every 15 minute period of the 24 hour day. So
the heater conserves energy by operating only when you need it!!
Clock setting
The programmable timer, as with all clocks, must be set to the correct time. If for example the time is 1:30 pm, rotate the
dial clockwise (following the direction of the arrow) until 13:30 is aligned with the triangular pointer.
IMPORTANT:
DO NOT ROTATE CLOCK DIAL COUNTER-CLOCKWISE.
The timer is in effect an electric clock and would only work while it is plugged into a power supply.
When unplugged, the timer stops and must be later re-set.
4