Filter
Top Products
5
A safety device
A safety device switches the heater off and emits a beepin the event of overheating. To
restart the heater, call the nearest Service center.
Note: To avoid overheating the appliance, do not cover it.
Tip over safety switch
A safety tip-over switch turns the heater off if it tips over or is positioned in an impro-
per way that could jeopardize safety. To reset, disconnect the plug from the outlet, put
the appliance in the upright position, then plug the appliance in again.
5. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow the radiator to cool. Wipe
radiator with a soft damp cloth; do not use detergents and abrasives. Should the radia-
tor not be in use over a certain length of time, roll the cable around the holder and
store it in a dry place. This appliance has been built to last for many years of trouble-
free service. In case of malfunction or doubt, do not try to repair the heater by yourself:
this might increase the risk of fire and electric shock. Call nearest Service Center Visit
www.delonghi.com for a completelist of Service Centers.
TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION
The appliance doesn’t
work
• Be sure it is plugged in
and that the electrical
outlet is working.
• Check for any obstruction.
• The switches are in the
OFF position.
• The thermostat may be set
too low.
• Plug into the mains.
• Remove the obstruction.
Let the appliance cool
down then reinsert the
plug into the mains. If
the appliance doesn’t
work please contact the
nearest service center.
• Switch on the appliance.
• Turn the thermostat to a
higher setting until the
heater restarts.
• Please check it is
correctly positioned