5
of the room.
6. Eco function
In this operating mode the appliance
will automatically set the power level
to guarantee the best comfort redu-
cing the energy consumption. In this
operating mode the unit may switch
the heating power level from maxi-
mum to minimum and viceversa,
several times in an hour. When using
the ECO function, the maximum tem-
perature setting is 79°F (26°C). To
activate this function, press the ECO
button (D).
7. If you want the appliance to distribute
the airflow over a larger area, press
the oscillation button (C) ( ). The
appliance will then oscillate right and
left. To stop the oscillation in the
desired position, just press oscillation
button (C) again.
8. To turn off the appliance press button
ON/OFF (A). The display will show a
count down for about 6 seconds.
NOTE: The display can show the tempera-
ture in both °F and °C. To change the tem-
perature scale, press and hold the + key for
few seconds, then release.
Please be informed that as this is not a pre-
cision device, the showed temperature not
necessary corresponds to the real one.
24-HOUR DIGITAL TIMER
This function can be activated from any
operating mode.
Delayed switch-on: with the appliance in
the OFF position, press the timer button
(E) ( ).
The display shows the symbol and
the time remaining before switch-on.
To set the timer, use the + and - adjust-
ment buttons (B), then wait a few
seconds for the programming to be set.
The display shows the symbol to
indicate you have set the timer. When
the programmed time has been rea-
ched, the appliance turns on with the
same settings it had during the pre-
vious operation.
Delayed shut-off: with the appliance on,
press the timer button (E) ( ). The
display shows the symbol and the
time remaining before shut-off.
To set the timer, use the + and - adjust-
ment buttons (B), then wait a few
seconds for the programming to be set.
The display returns to show the current
settings and the symbol to indica-
te you have set the timer. When the
programmed time as been reached the
appliance shuts off automatically.
If you want to go back to operation
without the timer, press the timer but-
ton (F) twice. The timer symbol
disappears from the display.
USING THE REMOTE CONTROL
- The remote control functions corre-
spond to those on the control panel.
See the section “Operation and Use"
on the previous page for a description
of the functions.
Inserting or replacing the batteries
- Remove the cover on the rear of the
remote control;
- Insert two AAA (R03/1.5V) batteries
(included but packaged separately)
making sure they are in the correct
position (see the instructions inside
the battery compartment);
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon-
zinc), or rechargeable (ni-cad, ni-mh,
etc) batteries
- Replace the cover;
- Old batteries must be removed and
disposed of in accordance with cur-
rent legislation as they are harmful to
the environment.
MAINTENANCE
- Before carrying out any maintenance,
always remove the plug from the
power outlet.
- During the season when the applian-
ce is being used, regularly clean the
air intake and outlet grilles using a
vacuum cleaner.
- Never use abrasive powders or sol-
vents to clean the appliance.
- Remove the back grille by pulling it
outward (Fig. 1).
- Remove the dust filter that filters
impurities from the air taken in from
the room, blow it lightly, then reposi-
tion it in the appliance.