DeLonghi SDH2000 Electric Heater User Manual


 
OPERATION AND USE OF THE ELECTRIC RADIATOR
Thank you for choosing a De'Longhi electric radiator.
For best results and maximum safety, read these instructions carefully before using the radiator.
Use the appliance for domestic use only!
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
the mains power supply corresponds to the value indicated on the rating plate on the back of the
appliance;
the power socket and electrical circuit are adequate for the appliance.
the mains socket matches the plug. If this is not the case, have the plug replaced;
the mains socket is adequately earthed. Failure to follow these important safety instructions
absolves the manufacturer of all liability.
1. GENERAL INSTRUCTIONS
The appliance can be operated from either the control panel or the remo-
te control. From the control panel only the mains functions are available
while on the remote control all functions are available.
To start the appliance, open the door at the back (see fig. 2) and turn the
main switch on. “ “ is displayed.
NB: This replaces the time display until the appliance receives a signal from the remote control.
After this, the time set on the remote control is displayed.
Press the ON/STAND-BY button on the control panel or on the remote
control to start the appliance on. The appliance can now be operated
from either the control panel or the remote control.
2. OPERATION FROM THE REMOTE CONTROL
I
NSERTING OR REPLACING THE BATTERIES
Remove the cover on the rear of the remote control;
Insert two R03 “AAA” 1.5V batteries in the correct position (see instruc-
tions inside the battery compartment);
Put the cover back in place.
NB: If the remote control unit is replaced or disposed of, the batteries must be
removed and disposed of in accordance with current legislation as they are harmful to the envi-
ronment.
S
ETTING THE TIME
When the batteries are inserted, the time display starts flashing. Use the + and - buttons until the
required time is displayed. Press the + or - buttons and hold them down to run through the minu-
tes and hours quickly.
To confirm the selected time, press the OK button. When the first command is transmitted from
the remote control, the time set on the remote control is shown also on the appliance display.
When setting the current time, the time can be zeroed quickly by pressing the "CANCEL" button.
The 12/24h button selects the way the time is displayed on the clock and timer.
3. OPERATING FROM THE CONTROL PANEL
"ON/STAND-BY" BUTTON: turns the appliance on in the last mode set or in stand-by awaiting com-
mands.
MODE BUTTON: enables the appliance to be used when the remote control is not available. The
"MODE" button can only be used to select the power level (MIN/MED/MAX). Both sides are active
3