Filter
Top Products
3
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce risk of
fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
Use handle when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet (0,9 m) from the front and top of the
heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any appliance is used by or near children and whenev-
er the heater is left operating and unattended.
4. Always unplug appliance when not in use.
5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunc-
tions, has been dropped or damaged in any manner. Return heater to authorized service
facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor loca-
tions. Never place appliance where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like.
Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect the appliance, turn controls to off, then remove plug from outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation opening as this may cause an
electric shock, fire or damage the appliance.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
13. A fan heater has hot or arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are used or stored.
14. Use this appliance only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into the
same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which becomes
hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet (recepta-
cle). Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging
heater into a worn outlet/receptacle/ may result in overheating of the power cord or fire.
17. Do not use an extension cord because the extension cord may overheat and cause a risk of
fire. However, if you have to use an extension cord, the cord shall be no. 14 AWG mini-
mum size and rated not less than 1875 watts, and has to be used only for supplying power
to this appliance.
18. Be sure that the plug is fully inserted into an appropriate outlet. Please remember that
receptacles also deteriorate due to aging and continuous use: check periodically of if signs
overheating or deformations are evidenced by the plug. Do not use the outlet and CALL
your electrician.
19. Check that neither the appliance nor the power cable have been damaged in any way dur-
ing transportation.
20. CAUTION: to prevent electric shock match wide blade of plug to wide slot, fully insert.
21. Do not cover the appliance while it is functioning in order to avoid overheating with the
attendant risk of fire.
SAVE THESE INSTRUCTIONS