Filter
Top Products
8
TEMPORARY INSTALLATION
Note: In both cases (permanent and temporary installations) make sure that the Pinguino is
positioned on level ground. If necessary use the two caster stops for the front casters
This installation makes it easy
to use Pinguino in any room,
provided there is a window or
a door: it allows you to use the
Pinguino immediately.
Suction discs may be used to
keep window or door closed.
Pinguino is equipped with an
adjustable window bracket. If
you have a sash window,
place the bracket on the
window sill, extend the
bracket fully within the window
frame and lower the window
onto the bracket. Insert the
nozzle of the exhaust hose
into the slot, then connect the
hose to the air conditioner
(fig.7). Thanks to the wing nut,
it’s possible to use the window
bracket also for sliding
windows. Position the hole of the
bracket so to allow a correct
installation of the exhaust hose
(see the following instructions).
30 cm
SET UP INSTRUCTION
For permanent installation place the Pinguino near the outlet opening in wall or window (where it is
meant to be used). The diagram below shows the correct way to install the exhaust hose.
1) Water collects at this point 2) Bend this section 3) Bend this section
NO YES YES
fig. 5 fig. 6
fig. 7
fig. 8
window
bracket