Filter
Top Products
9
ENGLISH
Turning on and programming
the unit
CONNECTING TO THE MAIN ELECTRIC
SUPPLY AND TURNING THE UNIT ON
1. Before plugging the unit into the socket,
check that:
• the main electric voltage corresponds to
the value indicated on the rating plate on
the back of the unit;
• the socket and power cord are ade-
quate for the voltage required;
• the socket is the right type for the plug,
otherwise have the socket replaced;
• the socket is effectively grounded. Failure
to observe this safety regulation absolves
the manufacturer from all liability.
2. Before setting the required function, check
that the timer switch is on “ I “ (manual).
If you want to use the timer, turn the switch to
the intermediate position .(timer on).
5
10
12
6
9
1
0
STOP
MANUALE
TIMER: SETTING THE TIME
As with all clocks, the programmer/timer must
be set to the right time. If it is 4:00 p.m., rotate
the pointers clockwise (follow the direction of
the arrow) until you reach 4:00 p.m.
Note: never rotate the timer dial in a counter-
clockwise direction.
TIMER: PROGRAMMING
1) Set the times when the unit will function by
pushing the notches in the required inter-
val towards the outside (each notch rep-
resents 15 minutes).
2) Check that the timer indicates the exact
time (see setting the time).
3) Choose the required function according
to the instructions on the following page.
The timer is an electric clock and only
works while the unit is connected to the
outlet. When it is unplugged or there is no
electricity, the timer stops (the clock is
“slow”) and must be re-set.
9
8
12
7
4
Period of operation
Example:
from 7:00 p.m. to 9:00 p.m.
In this mode, the unit will repeat the set pro-
gram every day.
Note: It is not necessary to modify the pro-
gram to exclude “timer” operation. Just turn
the switch to “ I “ (manual).
When the timer’s on the “0” (POWER OFF)
position, the appliance doesn’t work.
I MANUAL
O STOP
5751009900 17-04-2003 15:07 Pagina 9