Filter
Top Products
HOW TO USE YOUR MICATHERMIC FLAT PANEL RADIATOR
Thank you for choosing this De'Longhi heater. Please read this instruction booklet carefully before using this heater. By doing
so, you will obtain optimum results with maximum safety.
1. General instructions
Remove the heater from the packaging. Check that neither the heater nor the power cable has been damaged during tran-
sport. Do not operate the heater if damaged. Your heater is suitable for either freestanding or wall mounting usage. Do not
assemble the feet if wall mounting.
2. Electrical connection
- Before plugging in the appliance, check that your supply voltage is the same as that shown on the rating plate of the
appliance and that the power supply is able to with stand the power consumption (Watts) shown on the rating plate.
- If using more than one appliance at a time, it is important to ensure that the power supply is able to with stand the
power requirements.
3. Free standing operation
To fit the feet to the appliance, proceed as follows:
Fix the foot with the supplied screws, as shown in fig.1.
CAUTION: Never use this heater without feet when not wall-mounted.
ASSEMBLY KIT
The wall mounting kit contains:
4 x screws for wall mounting
4 x anchors (0.6 x 30) for wall mounting
1 x mounting bracket
REQUIRED TOOLS FOR ASSEMBLY AND ESTIMATED ASSEMBLY TIME
Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes
4. Wall-Mounting Installation
Before installing the unit , make sure of the following:
a. The heater is not located directly below a power outlet.
b. The power outlet can be easily reached by the plug and after installation.
21. Check that neither the appliance nor the power cable have been damaged in any way during
transportation.
22. Make sure that no pieces of polystyrene or other packaging material have been left on the
appliance. It may be necessary to pass over the appliance with a vacuum cleaner.
23. When switching on the appliance for the first time, allow it to run at full power for at
least two hours to get rid of the unpleasant smell. Make sure that the room in which
the appliance is located is well ventilated during this operation. It is normal for the
appliance to emit small cracking sounds when you turn it on.
24. CAUTION: to prevent electric shock match wide blade of plug to wide slot, then fully insert.
25. Do not cover the appliance while it is functioning in order to avoid overheating which may cause
risk of fire.
SAVE THESE INSTRUCTIONS
For Household use only
5