DeLonghi EW7507EBL Electric Heater User Manual


 
5
ELECTRONIC CLIMATE CONTROL
This heater has Electronic Climate Control (ECC) which automatically monitors and selects the ideal power set-
ting to maintain your chosen temperature.
If the selected temperature is higher than the actual room temperature, the appliance will start automatically
and rapidly heat the room until it reaches the selected temperature. The unit will automatically maintain the
temperature at a constant level, by switching between maximum, medium, minimum power and OFF.
If medium power level has been selected using the “ON MODE” button, the appliance will cycle between
medium, minimum power and OFF to maintain a selected temperature.
ANTI-FREEZE SETTING
Press the “ON MODE” button and select the maximum power level. Set the temperature to 42°F (5.6°C) with
the “ -” button. When set in this way, the appliance will turn on automatically only if the room temperature
falls below 42°F (5.6°C), to prevent freezing conditions.
Note: This function is not guaranteed in the event of power failures, lasting more than 2 minutes.
TIMER OPERATION
The timer allows you to set two programs in a 24-hour period. To program the timer:
Press the Timer button A (see Figure 2), this the following is displayed:
- The flashing message “--:--“;
- The message “ON” at the bottom left (ON time setting);
- The symbol “A” at the right indicating that the first program controlling is being set;
To set the “START” time press the “h” button to set the hour and “min” button to set the minutes, then
confirm the “START” time by pressing the “Timer button A” again.
The words “OFF” and “12:00” appear on the display.
Set the time you want the appliance to go OFF using the “h” button and “min” button, then confirm the
OFF time by pressing the “Timer button A” again.
At this point, the word “AUTO” appears at the top of the display and the “ ” indicator light comes on to
indicate that the appliance is ready to operate at the programmed time maintaining the preset comfort
temperature (fig.2).
- To set the program B press “Timer button B” and follow the same procedure as described for the program
A.
- Use the “ +” or “ -” buttons to set the desired comfort temperature, as
described above.
- When set in this way the heater will automatically switch on at the set time for the
designated time period and automatically maintain the preset comfort tempera-
ture. To cancel a preset program, press the timer button A or B once and then press the hour
button until the display shows “--:--“ (fig.3).
fig. 2
fig. 3