Filter
Top Products
Page 8 Page 9
Evaporative Cooler Safety Precautions Using your Evaporative Cooler
Unpacking
Remove the packaging and dispose of the
packaging material carefully. Follow the
instructions below for using the appliance.
Using the Cooler
Explanation of the function keys.
Plug in the cooler and you will hear a beep
Ÿ
beep. The appliance is in standby mode,
you can only use the ON/SPEED button.
OFF key: Press this button to exit
Ÿ
functions and enter into Standby mode.
ON/SPEED key: In standby mode, press
Ÿ
this key and the appliance starts from
medium speed then changes to low
s pe ed w it hi n 3 s ec on ds , t he
corresponding light will go on. The
appliance is under normal wind mode, the
corresponding low speed LED light is on.
Press the OFF key again to turn off the
appliance.
MODE key: Press the button once to
Ÿ
switch from normal to natural Mode, press
again to enter into sleep mode, Press for a
third time to exit wind mode selection. The
LED lights change accordingly.
SWING: Press this button once to activate
Ÿ
the rotating vent. Press again to exit swing
mode. The corresponding LED turns on
and off accordingly.
COOLER/HUMIDIFIER: Press this button
Ÿ
to activate the Cooling/Humidifying
function, the corresponding LED will
come on. The wind speed automatically
switches to LOW speed;
Wind Mode will stop temporarily even
though the LED is still on. 5 minutes later,
the Wind Speed and Wind Mode will
automatically restart to the status before
turning on the Cooler/Humidifier function.
The Wind Speed and Wind Mode can
then be adjusted.
TIMER: Press this button to set timing
Ÿ
from 0.5~7.5 hours.
Water Shortage Indication: Under
Ÿ
Cooler/Humidifier function, when the
water level reaches below the lowest
water level allowed, the appliance will
warn you for 10 seconds and then shut off
th e Co ole r/H umi dif ier fu nct ion
automatically.
The appliance will automatically cut off
Ÿ
power when the water tank is taken out.
The fuse (or circuit breaker) size should be
Ÿ
10 amperes.
Operate the appliance on a level surface.
Ÿ
Keep ventilation openings clear of
Ÿ
obstruction.
This appliance is intended to be used in
Ÿ
household and similar applications eg:
- staff kitchen areas in shops, offices and
other working environments;
- farm houses and by clients in hotels,
motels and other residential type
environments;
- bed and breakfast type environments;
-Catering and similar non-retail
applications.
Electrical Connection
This appliance should be properly
Ÿ
grounded for your safety. The power cord
of this appliance is equipped with a three-
prong plug which mates with standard
three prong wall outlets to minimise the
possibility of electrical shock.
Do not under any circumstances cut or
Ÿ
remove the third ground prong from the
power cord supplied. For personal safety,
this appliance must be properly
grounded.
This appliance requires a standard 240
Ÿ
Volt AC ~/50Hz electrical ground outlet
with three-prong. Have the wall outlet and
circuit checked by a qualified electrician to
make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is
encountered, it is your responsibility and
obligation to have it replaced with a
properly grounded 3-prong wall outlet.
The cord should be secured behind the
Ÿ
appliance and not left exposed or
dangling to prevent accidental injury.
The appliance should always be plugged
Ÿ
into its own individual electrical outlet
which has a voltage rating that matches
the rating label on the appliance. This
provides the best performance and also
prevent overloading house wiring circuits
that could cause a fire hazard from
overheated.
Never unplug the appliance by pulling the
Ÿ
power cord. Always grip the plug firmly
and pull straight out from the receptacle.
Repair or replace immediately all power
Ÿ
cords that have become frayed or
otherwise damaged. Do not use a cord
that shows cracks or abrasion damage
along its length or at either end.
When moving the appliance, be careful not
Ÿ
to damage the power cord.
If the supply cord is damaged, it must be
Ÿ
replaced by the manufacturer, its Service
agent or a similarly qualified person in
order to avoid a hazard.
Make sure that the plug is fully inserted into
Ÿ
the wall socket before use.
DO NOT fold or put kinks in the supply
Ÿ
cable or place heavy objects on it. It could
lead to cable damage.
Extension Cord
Because of potential safety hazards under
Ÿ
certain conditions, it is strongly
recommended that you do not use an
extension cord with this appliance.
However, if you must use an extension
cord it must be checked and tested by a
qualified technician or service person.
The extension cord must be a VDE-Listed,
3-wire grounding extension cord that has
a grounding plug and outlet and that the
electrical rating of the cord is 220-240
Volts and at least 10 amperes.
ON
SPEED
COOLER
HUMIDIFIER
MODE
TIMER
SWING
OFF