DeLonghi EW0507 Electric Heater User Manual


 
This heater has Electronic Climate Control which automatically monitors and selects
the ideal power setting to maintain your chosen temperature.
If the selected temperature is higher than the actual room temperature, the appliance
will start automatically and rapidly heat the room until it reaches the selected tempe-
rature. The unit will automatically maintain the temperature at a constant level, by
switching between maximum, medium, minimum power and OFF.
If medium power level has been selected using the “
ON MODE” button, the
appliance will modulate between medium, minimum power and OFF to maintain a
selected temperature.
ANTI-FREEZE SETTING
Press the “ON MODE” button and it is recommended to select the maximum power
level. Set the temperature to 42°F with the “-” button. When set in this way, the
appliance will switch on automatically only if the room temperature falls below 42°F,
to prevent freezing, at minimum energy consumption.
N.B.This function is not guaranteed in the event of power failures, lasting more than
2 minutes.
Programming the Electronic Timer
The timer allows you to set two programs in a 24h period.
To program the timer:
Press the “Timer button
A, this accesses the program, the following is displayed:
- The flashing message “--:--“;
- The message “
ON” at the bottom left (ON time setting);
- The symbol “
A” at the right indicating that the first program controlling is being set;
To setting the starting time press “hour button” to set the hour and “min button” to set the
minutes, then confirm the ON time by pressing the “Timer button
A” again. The words
OFF” and “00:00” appear on the display.
Set the time you want the appliance to go OFF using the “hour button” and “min but-
ton”, then confirm the OFF time by pressing the “Timer Function
A” button again.
At this point, the word “AUTO” appears at the top of the display and the “TIMER
ON” indicator light comes on to indicate that the appliance is ready to operate
at the programmed time maintaining the preset comfort temperature (fig.5).
- To set the program
B press “Timer button B” and follow the
same procedure as described for the program
A.
- Use the “
+” or “ -” buttons to set the desired comfort temperature, as
described above.
-When set in this way the heater will automatically switch on at the set time for the
designated time period and automatically maintain the preset comfort tempera-
ture.
5
AUTO
:
°F
fig. 5
GB 23-03-2004 16:21 Pagina 5