Filter
Top Products
4
SWITCHING HEATER ON
The heater must be connected to a properly polarized A/C
110/120 V household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material
away from the wall outlet where the heater plug is fitted in.
Turn the thermostat knob clockwise to the highest setting and push
one or both switches on. Pilot lights will go on, indicating that unit is
operating.
REMINDER
To completely shut unit off, both switches must be placed in "0"
position (lights off).
THERMOSTAT OPERATING
The thermostat operates on room air temperature and not heater
temperature. Counter clockwise direction - lower number, lower
temperature. Clockwise direction - higher number, higher temperature.
Switch your heater on as shown in the previous paragraph. When your room reaches a
comfortable temperature, turn thermostat knob back gradually until you hear a "click" and not
HOW TO USE YOUR HEATER
FEET ASSEMBLING
Remove the feet from the packing.
Fit the feet to the appliance as follows:
1 Insert the anchor pins (A) into the slots and turn the foot until it clicks into position (fig. 1).
2 Fasten the feet in position using the screw (fig. 2).
BE CAREFUL
Operate the heater in upright position only.
Any other position could create hazard situation!
The appliance is fitted with a tilt-swich which turns the appliance off if it should fall over. To
restart the appliance, simply place it upright again.
LOCATION
Place heater on floor beneath coldest window in the room or any desired location. Your heater
will minimize the effect of cold drafts.
The heater must not be located immediately below a socket-outlet.
A
fig. 1 fig. 2
1
2
3
4
5
6
0