Filter
Top Products
6
- Use the appliance always and only in the
vertical position.
- Do not use the appliance to dry laundry,
and do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not operate the appliance in contact
with walls, furniture, curtains, etc.
- If the power cord is damaged, it must be
replaced by the manufacturer, the authori-
zed service facility, or a qualified electri-
cian, in order to prevent the risk of mal-
function.
- Do not cover the appliance while it is ope-
rating, as this could potentially cause a
fire.
- Do not use this appliance in a room smal-
ler than 43 square feet (4 m²).
- Heaters should never be used with an
extension cord or outlet strip. Heaters
should be plugged directly into an outlet.
- Before storing the appliance, check it is
completely off and the cable is unplugged.
At this point wrap the cord around the
base. Do not store in a dusty room. The
room temperature should be between 32-
86°F (0-30°C). Do not load anything above
it.
- Heaters draw more current than small
appliances, overheating of the outlet may
occur even if it has not occured with the
use of other appliances.
Additional safety features
1. Overheating protection: a safety device
switches the heater off if it accidentally
overheats (e.g.: air intake and outlet gril-
les obstructed, filter clogged). In this case
remove the plug from the power outlet and
leave it unplugged for a few minutes, eli-
minate the cause of overheating, then plug
the fan heater back and turn it on again.
2. Tip over safety switch: a safety tip-over
switch turns the heater off if it tips over or
is positioned in an improper way that
could jeopardize safety. The appliance
emits a beep and the display will show a
blinking dot. After the appliance has been
restored in the vertical position it will take
just few seconds to start on again.
Note: To avoid overheating the appliance, do
not cover it.
TROUBLE-SHOOTING
In case “PF” is displayed and a warning sound
is emitted, there is a fault on the temperature
sensor. If the problem persists contact the
Service Center.
If the appliance shuts off unexpectedly:
- Check that the appliance is receiving
power.
- Check that the appliance is in the vertical
position and on a flat surface, as the
safety tip-over switch may have been trip-
ped.
- Check the temperature set and the timer:
the appliance may be off because the set
temperature has been reached or the time
set on the timer has elapsed.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digi-
tal
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. lf this equipment does cause harm-
ful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s authority to
operate the equipment.