Filter
Top Products
7
OPERATING RANGE
The operating range of the air conditioning
unit goes from a minimum of +17°C (62°F) to a
maximum of +35°C (95°F), with a choice of
temperatures in cooling mode of from +17°C
(62°F) to + 31°C (87°F).
In dehumidifying mode, the operating range
goes from +20°C (68°F) to + 31°C (87°F). The
temperature cannot be selected in advance.
POWER SUPPLY
• Plug the air conditioning unit into a suita-
ble outlet. Do not connect to multiple
sockets.
• Once plugged into the outlet, wait about
two seconds until you hear a beep, then
press the " " button to turn the applian-
ce on.
OPERATING IN AIR CONDITIONING MODE
1. Make sure the condensation tank is cor-
rectly in place.
2. Press the "MODE" button repeatedly until
the air conditioning mode is selected.
"COOL" appears on the display.
While the unit is operating in air conditio-
ning mode, always place the exhaust
hose through an open window to eject
the hot air from the room.
3. Press the “SET TEMP” button to set a suita-
ble room temperature between +17°C
(62°F) and +31°C (87°F).
4. Press the FAN SPEED button to select a sui-
table fan speed: Max, Med, Min.
OPERATING IN DEHUMIDIFYING MODE
1. Keep the windows and door closed to
make dehumidification of the room more
efficient.
2. Make sure the condensation tank is cor-
rectly in place.
3. Repeatedly press the "MODE" button to
select the dehumidifying mode. "DRY"
appears on the display.
4. Neither the fan speed nor temperature
can be regulated.
5. Do not use the exhaust hose to expel the
air outside. The hot air given out at the
back of the appliance should not be
expelled from the room.
Operation
SETTING THE REMOTE CONTROL CLOCK
Remove the cover of the battery compartment on the back of the remote control unit.
After inserting two 1.5 V alkaline batteries in the compartment, the clock is automatically set at 12:00. If you want to
set the time to 10:30, proceed as follows:
Press the CLK button (in the battery compart-
ment) with a pointed object such as a pencil.
The time indicator on the display flashes and the
correct time can be set.
1
Press the HOUR button on the remote control unit
to set the hours (set to 10 am).
2
Press the MIN button on the remote control unit
to set the minutes (set to 30).
3
Press the CLK button again to confirm the opera-
tion, then replace the battery compartment
cover.
4
CLK
ACL
Note: the RST button (reset) in the battery compartment cancels all the settings on the remote control unit (once pres-
sed, the current time must be re-set).
Important: make sure you do not reverse the poles of the batteries.
GB 18-11-2003 13:57 Pagina 7