Filter
Top Products
INSTRUCTION
ALWAYS use Heater in accordance with
instructions supplied with each Heater. Keep
instructions in a safe place.
1
DO NOT place clothes or other materials on
the Heater, as apart from the danger of fire
their presence could affect the efficient
working of the appliance.
2
DO NOT position Heater close to chairs
and fabrics
3
DO NOT move Heater from room to room
when it is lit.
4
DO NOT position Heater alongside a wall or
near curtains, etc. ALWAYS face Heater
towards centre of room.
Special care should be taken if the Heater is
on a surface where it can move or twist on its
wheels or castors if knocked by a child or
dog, etc.
5
IF a leak is suspected, turn the gas off at the
cylinder. DO NOT disconnect the regulator.
Extinguish all naked lights. Check all connections.
Slowly turn the gas on and brush the connectors
with soapy water or liquid detergent - a gas leak
will form bubbles. If a leak is found turn the gas off
and inform your Dealer. DO NOT use the heater
again until it has been inspected by your Dealer. If
the cylinder valve appears to be leaking when
turned off, refit the Black Branch Cap or Orange
valve Cap.
6
HEATER SAFETY INSTRUCTIONS. (KEEP IN A SAFE PLACE).
SPARE COPIES OF THIS LEALET CAN BE OBTAINED FROM YOUR DEALER
- This appliance MUST NOT be used in a basement, high rise flats, bathrooms or bedrooms and in rooms having volume less than
15 m
3
(30m
3
in living rooms) for three burner models; 18m
3
(36m
3
in living rooms) for two burner models.
- Be sure installation is complying to local standard.
- Do not install the appliance in a room which might contain gas, oil or sulphur, or near sources of heat.
- The heater you have purchased is fitted with safety devices which come on in the event of malfunctioning while the appliance is in use. If
the pilot (placed opposite the burner) accidentally goes out, or if the room is not sufficiently ventilated, the safety device will block the gas
flow, causing the heater to go off.
VENTILATION
USE ONLY IN WELL VENTILATED ROOM.
DO NOT CHANGE CYLINDERS IN THE PRESENCE OF NAKED LIGHTS.
NEVER USE A MATCH OR NAKED FLAME TO SEARCH FOR LEAKS.
A LEAK WILL SMELL
2
1) Place the gas cylinder in the gas cylinder
compartment and connect the regulator to
the cylinder as shown on page 3.
2) To fit the backcover, insert the two tabs
located on the left-hand side of the
backcover into the corresponding slots in
the cabinet. Then insert the tab on the
right hand side into its slot.
IMPORTANT: to remove the backcover,
lift the backcover and pull clear of the
slots.
ASSEMBLY
Gas cylinder
compartment
Tabs
Slot