Filter
Top Products
IPv4 address for storage controller module 1: port 1 ___ . ___ . ___ . ___
IPv4 address for storage controller module 2: port 1 ___ . ___ . ___ . ___
(Four port I/O card only) IPv4 address for storage controller module 1:
port 3
___ . ___ . ___ . ___
(Four port I/O card only) IPv4 address for storage controller module 2:
port 3
___ . ___ . ___ . ___
Table 4. iSCSI Fault Domain 2
Target IPv4 address ___ . ___ . ___ . ___
Subnet mask ___ . ___ . ___ . ___
Gateway IPv4 address ___ . ___ . ___ . ___
IPv4 address for storage controller module 1: port 2 ___ . ___ . ___ . ___
IPv4 address for storage controller module 2: port 2 ___ . ___ . ___ . ___
(Four port I/O card only) IPv4 address for storage controller module 1:
port 4
___ . ___ . ___ . ___
(Four port I/O card only) IPv4 address for storage controller module 2:
port 4
___ . ___ . ___ . ___
Additional Storage Center Information
The Network Time Protocol (NTP) and Simple Mail Transfer Protocol (SMTP) server information is
optional. The proxy server information is also optional, but it may be required to complete the Discover
and Configure Uninitialized SCv2000 Series Storage Centers wizard.
Table 5. NTP, SMTP, and Proxy Servers
NTP server IPv4 address ___ . ___ . ___ . ___
SMTP server IPv4 address ___ . ___ . ___ . ___
Backup SMTP server IPv4 address ___ . ___ . ___ . ___
SMTP server login ID ________________
SMTP server password ________________
Proxy server IPv4 address ___ . ___ . ___ . ___
Fibre Channel Zoning Information
For a storage system with Fibre Channel front-end ports, record the physical and virtual WWNs of the
Fibre Channel ports in Fault Domain 1 and Fault Domain 2. This information is displayed on the Review
Front-End page of the Discover and Configure Uninitialized SCv2000 Series Storage Centers wizard.
Use this information to configure zoning on each Fibre Channel switch.
See the Dell Storage Center SCv2000/SCv2020 Storage System Deployment Guide for information about
setting up Fibre Channel zoning.
6