Defy Appliances 835 Stove User Manual


 
SOLID PLATES
Red dot plates
Plates featuring a red dot in the centre are high speed, high
wattage plates for increased performance
For your safety these plates are fitted with thermal limiters.
Should a plate be accidentally switched on and left
unattended, the limiter will reduce the power output of the
plate and minimise the risk of overheating and the possibility
of fire.
Caring for Solid Plates
Before using the plates for the first time, switch them on for about 4 minutes at the
highest setting. This allows the factory applied protective coating to burn in.
To prevent blotchy discolouration and corrosion, moisture from spatters and spills
should be cleaned off immediately.
To clean the plates, wipe them with a damp cloth or nylon pad. A little liquid
detergent may be used. Do not use metal scourers or sharp metal objects to clean the
plates.
After cleaning, dry the plates by switching them on for a short while.
To prevent rust, periodically apply some, sewing machine oil or electrical hotplate
polish - available from Defy Service Centres. Extra attention is required in areas of
high humidity or in close proximity to the sea.
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT OR
REPAIR OF RUSTED OR CORRODED PLATES.
Recommendations
Use only pots with a solid level base. An uneven base can prolong cooking times and
waste energy.
Use pots with a base diameter slightly larger than the plate. This will ensure even heat
distribution and prevent spillage from dripping onto and staining the hot plate.
Always cover the pot with a lid. This will conserve energy and minimise spillage.
Thermal shock could damage the plates. Do not put cold pots on very hot plates.
Plate controls—variable
Select the heat level by turning the knob to the
required setting.
You may select any setting.
1= low , 3 = medium and 6 = high.
The illuminated display will glow, when the plate is
switched on.