Defy Appliances 150 Stove User Manual


 
Page 3
Flexible hose - Not supplied.
Any hose that is used to connect the stove to the gas system shall comply with
SANS 1156-2 or BS 3212.
Temporary installation.
Flexible hose connection from the gas appliance to the cylinder can be made by the
user. Ensure that pipe clamps are tightened correctly and are of good quality.
Gas cylinder - Not supplied.
For best results we recommend that gas cylinders with a minimum capacity of 19kg
be used.
Regulator - Not supplied.
A 2,8 kPa LPG gas regulator which complies with SANS 1237 must be used.
Permanent installation.
The appliance may only be installed by a Qualified Gas Fitter who is registered with
the LPGSASA. (Liquid Petroleum Gas Association of Southern Africa)
All registered Gas Fitters are issued with an identity card which carries their
registration number. Make a note of this in the box below.
The Gas Fitter should also provide you with a written certificate after completion of
the work. Failure to comply with the above will render the warranty invalid.
Before the installer hands over the installed appliance be sure that you fully
understand:
a) The position of the isolation or shut-off valve in the gas supply line to the appliance.
b) The requirements for safe operation of the appliance.
Note:
This appliance is supplied ex-factory with jets and air settings for use
with LPG gas only.
We strongly recommend that the changing of the jets and air flow
adjustment be carried out by a trained Defy technician.
Installer’s details to be filled in below
Safety compliance with local requirements