DCS BGB131 Burner User Manual


 
INSTALLATION OF SIDE BURNER:
All BGB131 and BGB132 models can be installed in
combustible enclosure with zero clearance from the
back,sides and bottom.
A minimum of 6” from the back and sides must be
maintained from the Professional Side Burner above
the cooking surface and a minimum of 1” below the
cooking surface to combustible construction (see
Fig. 01).
When determining a suitable location, take into
account concerns such as exposure to wind,proximity
to traffic paths, and keeping any gas supply lines as
short as possible. Locate the Side Burner only in a well-
ventilated area. Never locate the Side Burner in a
garage,breezeway,shed,or other such enclosed areas.
SAFETY PRACTICES & PRECAUTIONS
4
SPIDER AND INSECT WARNING!
Spiders and insects can nest in the burner(s) or orifices of this or any other gas
appliance,and can block or restrict the burner. This can cause a flash back to
the control panel.This is a very dangerous condition which can cause a fire to
occur,thereby damaging the unit and making it unsafe to operate.
Yo u mustinspect the burner(s) at least once a year or immediately if any of the
following conditions occur:
1. The smell of gas in conjunction with the burner flames appearing yellow.
2. The Professional Side Burner does not reach temperature.
3. The Professional Side Burner heats unevenly.
4. The burner(s) make popping noises.
Do not attempt to disconnect any gas connections while your burner is in use,or the gas supply
is on.
When the Professional Side Burner is stored indoors the gas supply must be disconnected and,
if using an LP gas cylinder,the cylinder must be stored outdoors in a well-ventilated area.
Keep any electrical supply cord away from the heated surfaces of the Professional Side Burner.
On cart mounted units, never move without first allowing the Side Burner and/or grill to cool
and ensuring that the gas supply is turned off. Fold the side shelf down, and push; never pull
the grill.
Never use the Professional Side Burner in a windy area.
FIG.01
SIDE BURNER 131/132 SIDE MOUNT
MODEL INSTALLATION
1" min.
6"
IGNITION
BURNER