Filter
Top Products
PSP 1000/2000/3000 users
Ensure you have a memory stick in your PSP with a minimum capacity of
3MB.
Remove any UMD discs.
Connect your PSP to your PC using the provided USB cable.
Switch on your PSP and wait for the crossbar to appear.
Navigate using your directional pad to the “Settings” bar and select “USB
Connection”.
3. Your PSP is now connected to your PC and will appear as a removable disk
drive (it may be shown as any drive letter from ‘D’ to ‘Z’). The setup utility will
automatically detect your PSP and ask you to confirm that it has detected the
correct drive letter.
If for some reason the correct drive letter is not detected you can select it
yourself by clicking the “I’ll Select My PSP Drive” button. Use the “Next” button
to select the correct drive letter and confirm by selecting “Yes this is my PSP
drive” to proceed with the installation.
4. The setup utility will now install Action Replay to your PSP memory stick or
system memory if you own a PSP go.
5. Exit USB mode on your PSP and follow the steps below which are relevant for
your PSP version:
PSP go users
Navigate using your directional pad to the “Game” bar, select “System
Storage” and then select “Action Replay”.
PSP 1000/2000/3000 users
Navigate using your directional pad to the “Game” bar, select “Memory Stick”
and then select “Action Replay”.
6. Action Replay at this point will run but only in a ‘Demo’ mode. It needs to run
this once in ‘Demo’ mode to obtain your PSP’s ID. To activate Action Replay
fully you will now need to exit Action Replay and re-connect your PSP to your
PC. Press the Home button and exit back to the PSP crossbar screen. Navigate
using your directional pad to the “Settings” bar and select “USB Connection”.
7. Now on your PC, ensure you have re-connected your PSP. The setup utility will
detect your PSP ID and prompt you to enter your Action Replay license key (this
can be found upon this manual or supplied if you purchased Action Replay
Online). Once you have entered the provided license key click the ‘Next’ button
to continue.
8. Once the installation is complete this will be confirmed by the setup utility,
when prompted to do so disconnect your PSP and exit USB mode.
You are now ready to start Action Replay, please read the following section
“Using Action Replay”.