Filter
Top Products
6
H
H
OW
OW
Y
Y
OUR
OUR
A
A
PPLIANCE
PPLIANCE
W
W
ORKS
ORKS
Cautions:
Do not try to operate your stove with viewing door open. Pellets will not feed under these
circumstances and a safety concern may arise from sparks or fumes entering room.
If you are not drawing combustion air from outside, care must be taken to allow for adequate air
make up, to avoid possible room air starvation when stove or other exhaust fans are in
operation.
It is highly recommended that you install a high quality smoke detector as well as a carbon
monoxide gas detector in the room where stove is installed. Care should be taken to make
sure detectors are in working order at all times.
Fuel in the form of wood pellets , shelled corn or grain is stored in the hopper. An
auger delivers the pellets to the burn grate. The fuel rate, or heat output, is set by
adjusting the feed rate touch pad, (settings 1 to 4). A fan provides combustion air to
the burn grate. The amount of combustion air in the burn grate is adjustable and
automatically changes as the fuel rate changes. The higher the fuel rate, the larger
the amount of combustion air and visa versa. The fuel burns in the burn grate,
producing heat. Some heat radiates out the front of your stove. The majority of the
heat passes around the heat exchange tubes and air plenum around the firebox and
is then moved into the room by the room air fan. A small amount of heat must pass
out the exhaust of your stove, along with gases, into the atmosphere.
Your stove's heat output can be adjusted from setting 1-4, through the FEED RATE
touch pad, to vary your heat
output from Low to High.
The room air fan can be
manually adjusted through
the FAN SPEED to run
faster or slower to
correspond to the amount of
heat being produced. The room air fan is also on a
limit switch, controlled to run on high when the stove
reaches higher temperatures and then resume the
speed you had selected once it cools to a lower
temperature.
Your stove can run efficiently over extended periods of
time and at different heat output levels as long as the
fuel supply is uninterrupted and timely cleaning and
maintenance is preformed. An example of how
improper cleaning effects operations is; the
exhaust pressure switch will shut the pellet supply off
and your stove will shut off if the exhaust system be-
comes plugged.
The operations and maintenance of your Glow Boy Series of multi-fuel appliance are unique and
should not be considered to be like a wood, coal, gas, electric, propane or oil heater, stove or appliance.
FUEL CONSIDERATIONS
Your Glow Boy Series of Multi-fuel appliance is designed to burn the following:
1. Wood pellets that comply with the Pellet Fuel Industries standards.
2. A combination of up to 50/50 Wood Pellet and Shelled Corn
3. 100% Shelled Corn or Grain, using the Multi—Fuel Grate, and manual start only, No Igniter.
Window
Burn Pot
Burn Grate
Heat Tubes
Tube Scraper
Ash Pit
Hopper
Fan Motors
Auger
Exhaust
A
ir Intake
A
uger Motor
Base
Hopper Lid
as desiredas desired
Memory &
Fan Trim
Glow Boy Home & Shop Heater www.glowboystoves.com 6