Filter
Top Products
IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE
The controller on your stove has been fitted with
memory. Should you have a power outage or blip,
the unit will come back on the setting that you had
left it at before.
Before you first plug in a new stove after installation,
make sure you have removed all foreign objects
from the hopper. When you first plug in the stove,
it may possibly power up due to the initial memory
test. At this time press the OFF button.
NOTE: Corn stoves DO NOT USE AN
IGNITER. The igniter light is the 15 min. delay until
the unit reaches the required operating temperature.
This control is equipped with various functions. As
a result, you need to check to make sure you are in
the proper burn mode. Once your desired setting is
reached, press the START button for operation.
To confirm the mode, press and hold the OFF button.
When the desired mode flashes as stated below,
release the OFF button and press START.
You may hit the START button if you are ready with a full hopper of fuel.
* The thermostat is available separately from the stove.
The 3 modes are as follows:
When the red FEED RATE lights 3 and 4 flash,
that is the High/Low Thermostat Cycle (optional *).
1
When the red FEED RATE lights 1 and 2 flash,
that is the On/Off Thermostat Cycle (optional *).
2
When the red FEED RATE lights 1 and 4 flash,
that is the manual function.
3