PART IDENTIFICATION
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING
1) Check available power supply and
resolve any wiring problems BEFORE
installation and operation of this unit. All
wiring must comply with local and national
electrical codes and be installed by a
qualified electrician. If you have any
questions regarding the following
instructions, contact a qualified electrician.
2) This appliance draws 10 nameplate amps
under Cooling Mode and may be used in
any properly wired, general purpose 13 amp
household grounded receptacle.
3) For your safety and protection, this unit is
grounded through the power cord plug when
plugged into a matching wall outlet. If you
are not sure whether the wall outlets in your
home are properly grounded, please consult
a qualified electrician.
WARNING: Improper connection of the
grounding plug can result in risk of Fire,
Electric Shock, and/or injury to Persons
associated with the appliance. Check with a
qualified service representative if in doubt
that the appliance is proplery grounded.
4) DO NOT USE PLUG ADAPTERS OR
EXTENSION CORDS WITH THIS UNIT. If it
is necessary to use an extension cord with
this unit, use an approved “air conditioner”
extension cord only (available at most local
hardware stores).
5) To avoid the possibility of personal injury,
always disconnect the power supply to the
unit before installing and/or servicing.
ELECTRICAL
SPECIFICATIONS
TABLE 1
Suggested Individual Branch Circuit
Nameplate Amps *AWG Wire Size
10 16
AWG- American Wire Gauge
*Based on copper wire at 105°C temperature rating.
TABLE 2
Receptacle and Fuse Types
Rated Volts 125
Amps 13
Wall Outlet
Fuse Size 15
Time Delay Fuse Plug Type
(or Circuit Breaker)
CAUTION: Do not leave this unit
unattended in a space where people or
animals cannot react to a failed unit are
located. A failed unit can cause extreme
overheating or death in such an
enclosed, unattended space.
3
Air Exhaust
LCD
Display
Front
Panel
Handles
Wheels
Air Filter
Air inlet
Air outlet
Cover
Electricity
cable
Water drain
Air inlet