Filter
Top Products
Remote Control Operating
Instructions
1.
Sending Signal:
The remote control must be
aimed directly at the infra-red eye located below
control panel when initiating a command. When
the remote control is switched on and a button is
pressed, a beep will sound (main unit) confirming a
signal was sent/received. All program selections
appearing in the remote control display will appear
in the display of the main unit when both units are
operational. If the main unit does not respond to
the command issued, try the procedure again.
If the main unit again fails to respond;
Check the following:
• Are the receiver and the remote unit within the
required 7 meter (23 ft.) operating distance?
• Is the receiver window on the main unit partially
blocked and/or obscured?
• Are the batteries correctly installed inside the
remote (positive+ / negative-)?
• Check the batteries. If low, replace.
2. Setting/Adjusting Time of Day Clock
(Remote Control):
When the batteries are first
installed, the clock display flashes “0:00”. Press
the MIN button to set the correct (minute) time.
Each time the MIN button is pressed the time is
increased in 10 minute increments. The time sets
automatically (stops flashing) after 5 seconds.
Press/hold the HOUR button to select/change the
correct hour time. (time flashes) Each time the
HOUR button is pressed the time will increase in 1
hour increments. The time automatically sets
(stops flashing) after 5 seconds. When the main
unit is swithed on using the remote control, the
time on the main unit will automatically adjust to
the time set on the remote control.
3.
Mode Setting:
Press the “Mode” button to select
operating mode. Each time the button is pressed
will advance to a different setting
(Auto–Cool–Dry–Fan).
4. Temperature Setting: Press the remote
+ buttons to select the desired
C/F operating temperature.
- Each time a button is
pressed the temperature will
increase/decrease 1°C/F. The temperature
selected will appear in the remote display.
When the main unit is swithed on using the
remote control, the temperature on the main
unit will automatically adjust to the
temperature set on the remote control.
Temperature ranges from 16˚C-31˚C
(60.8F ~ 88F)
5. Fan Speed Setting: Press the “Fan” button to
select the operating fan speed. Depending on the
mode selection, the fan button will advance to a
different fan speed (Auto–Low–Medium –High)
The fan speed selected will appear in the
display window.
i.e.
MODE FAN SPEEDS
Cool Low–Medium–High
Dry Low
Fan Low-Medium-High
AUTO Low–Medium–High
2
18
LCD Window
3
4
5
6
8
Timer On/Off