Filter
Top Products
6
1. Assembly of the Upper Channel, to
Cabinet.
• "L" Shaped Top Channel: Install the "L"
shaped channel to the top of the cabinet as
shown in Fig.3 using four(4)3/8"(10mm)screws.
2. Assembly of the Side Curtains to
Cabinet.
• Extend the shutter from the shutter frame and
slide it into the shutter tabs on the side channel
of the air conditioner as shown in Fig. 4.
• Slide the shutters into the top (“L” Shaped) and
bottom (“U” Shaped channels. The shutters are
identified (on frame) as left & right.
3. Completing the Installation
•
Cut the foam (non adhesive) sealing strip to
fit the area of the window sill that the air
conditioner will rest on.
3a.
Completing the Installation (cont’d)
• Carefully place the air conditioner into the
window with the “L” shaped mounting brack
et
(on top) positioned in front of the upper window
sash.
The bottom of the cabinet should be
positioned on the “recessed” portion of the
window frame. Pull the window down until it
rests just behind the front flange of the (top) “L”
shaped mounting bracket.
See Fig. 5.
• Expand the shutter frames (fully) on each side
and secure the top of the frames to the window
sash using one 3/4"(19mm)screw on each side
and one
in the “L” shaped mounting bracket.
See Fig. 5
•
Secure the shutter clamp on each side of the
(lower) shutter and secure to window sill using
one 3/4"(19mm)screw on each side. Fig.5
• Place the second foam sealing strip to fit the
opening between the inside and outside windo
ws
then attach the safety lock to the outside window
frame using one 3/4
”(19mm) scre w. See Fig. 6.
PLEAS
E NOTE: Window applications come in a
variety of di
fferent styles. Therefore, it may be
necessary to modify or improvise your particular
installation.
3/8"(10mm) Screw
“L” Shaped
Mounting Bracket
Fig. 3
“U” Shaped Channel
(Factory Installed)
Fig. 5
“L” Shaped
Mounting
Bracket
Window Sash
Fig. 6
Foam Seal
Shutter clamps
Safety Lock
3/4"(19mm) Screws
3/4"(19mm) Screw
Shutter Frame
Shutter
Fig. 4
Shutter Tabs
s
b
a
t
o
t
n
i
n
w
o
d
e
d
i
l
S