Filter
Top Products
WARN Negative output used to drive bulb for warning output, only used in suicide pin mode. It is capable of switching
0.25A, equivalent to a 3 watt 12V bulb. Connect one wire from bulb to terminal and other wire to fused +12V.
If a larger or high power indicator is used a relay should be used to turn on the light. In this case connect one
side of the relay coil to the WARN terminal and the other side to fused +12v. The relay contacts will then be
used to power the light. Any 12v automotive relay can be used, such as the Dakota Digital, RLY-1 30A relay.
SPD Speed input required only if using lock on speed setting, leave unconnected otherwise.
For 2 wire pulse generators connect one wire to ground and the other wire to SPD terminal. If the signal is
being shared by a cruise control or ECM, make sure they all use a common ground for the pulse generator.
For 3 wire Hall-effect sensors, refer to the installation instructions for the sensor to determine wire color code.
Most 3 wire sensors use the following color code: RED – power, BLACK – ground, WHITE – speed signal.
For speed sensor integrated into a vehicle wiring harness, consult a service manual to determine the color
code and location of the speedometer signal.
L PIN Required if suicide safety pin mode set (switch 1). If not used leave
& R PIN unconnected. These are inputs from the switches on the suicide safety pin assemblies. The switch will
connect the R PIN or L PIN terminal to ground when the pin is fully actuated. If either of the switches fails to
close when pins are to be locked, the warning tone and output are activated.
IGN Should be connected to have +12v when key is ON. The auto-lock module will not operate unless it receives
the ignition signal.
GEAR Required if set to lock or unlock using park signal and using Dakota Digital gear sender (GSS-1000, GSS-
2000…) in 1-wire gear signal mode. Connect the 1-wire gear signal wire from sending unit to this terminal. If
not used, leave unconnected.
PARK Required if set to lock or unlock on park and a +12V park signal is used. When +12v is applied to the park
terminal, it is read as the vehicle being in park. If not used, leave unconnected.
NOTE: Use either the GEAR terminal or the PARK terminal, but do not use both. The unused terminal should be
left unconnected.
4510 W. 61ST St. N., Sioux Falls, SD 57107
Phone: (605) 332-6513 FAX: (605) 339-4106
www.dakotadigital.com
dakotasupport@dakotadigital.com
©Copyright 2005 Dakota Digital Inc.