Filter
Top Products
7.
PIR settings (Figure 4)
The jumpers settings are as follows:
Range: High: more than 50 feet
Medium: 20-50 feet
Low: less than 20 feet
LED: ON: LED will ash when it detects
OFF: LED is always dark
Filter: ON: set for outdoor use
OFF: set for indoor use
Reset: 10 seconds to reset after activation
120 seconds to reset after activation
Note: If the range is set to “low,” the lter should
be set to “o” or the detection will be limited.
Reset Filter LED Range
Figure 4
PIR with cover removed