Filter
Top Products
ENGLISH
93
Start
Connect the unit with the power.
The OPERATION lamp on the display panel of the indoor unit starts flashing.
(1) Mode select button (MODE)
Select COOL, HEAT (cooling only type without), or FAN ONLY.
(2) Temperature button (TEMP)
Set the desired temperature.
Cooling 21ºC or higher
Heating 28ºC or lower
(3) Fan speed button (FAN SPED)
Select any of the "AUTO" "LOW", "MED" and "HIGH".
(4) ON/OFF button
Push this button to start the air conditioner.
The OPERATION lamp on the display panel of the indoor unit lights. The opera-
ting mode is selected in accordance with the room temperature and operation
starts after approximately 3 minutes (If you select FAN ONLY mode, the unit will
start immediately.)
Stop
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1,3, and 4 to select this mode.
COOLING/FAN ONLY OPERATION
06ManualMandoDaitsuEng 21/12/06 16:17 Página 93