Daewoo DHC-600 Dehumidifier User Manual


 
4
Operating Conditions:
This unit is designed to operate with a working environment between 13 and 35 .
If the unit has been switched off and needs to be switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other
electrical appliances.
Select a suitable location, making sure you have easy access to an electrical outlet.
Plug the unit into a 115V~ 60Hz electrical socket-outlet with earth connection.
Make sure the Water Tank is correctly fitted otherwise the unit will not operate properly.
1. Plug the cord to the proper power requirement. The computer system of the unit will have a
self-check. If it is normal, the POWER indicator flashes at 0.5Hz. Press ON/OFF button now,
the unit will start operating under DEHUMIDIFYING mode with 60% setting humidity. Press the
HUMIDITY or button will change setting humidity.
2. Press the CONTINUE button will go into continues dehumidifying mode, and this time the
HUMIDITY and button are disable.
3. Press the ON/OFF button to turn off the unit.(You do not meed to unplug the power cord except
when the unit will not be in use for a long period of time.)
OPERATING INSTRUCTIONS
Turning the unit ON or OFF
OPERATION
Water Tank
Water will drain into the tank. When the tank is full and the unit stops operating,
the Water Full indicator light will flash.
Do not remove the water tank whilst the machine is still working or just stopping.
This might cause some water to drip.
To empty the water tank, remove the tank as shown, empty the water and replace
the tank back in the unit. Ensure components of water tank are correctly positioned.
The machine will re-start when the water tank is restored in its correct position.
1. Drag out the bucket a little.
2. Hold the two sides of the
bucket with even strength,
and pull it out from the unit.
3. Pour the water out.