Filter
Top Products
12
OPTION PROGRAMMING
7. DOUBLE UNLOCK PULSE
With this feature enabled, the unit will send 2 unlock pulses when the #2 Unlock button is pressed. 2 pulses are required for
interfacing into some existing Factory Keyless Entry or Alarm systems on vehicles such as Nissan, VW, Toyota, and Lexus
vehicles.
8. SILENT ARMING /DISARMING (CHIRP DEFEAT)
With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular Lock/Unlock
Buttons. Flashing parking lights will be the only Arm/Disarm confirmation.
9. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a crowded parking lot
or structure. Light will stay on for 30 Sec. or until Ignition is turned on.
10. DISARM WITH AUX. OUTPUT 1 (TRUNK POP)
Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is turned on
the unit will DISARM when opening trunk or using an auxiliary device controlled by the Gray output wire.
11. N/A, No option
12. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required for 1980’/90’s
European Vehicles that require a long pulse to do Vacuum door lock systems.
13. ACTIVE, PASSIVE, or FULL-TIME CARJACK PROTECTION
This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1 (Lock) = Active
protection. Button 2 (Unlock) = Active / Passive protection. Button 3 (Trunk) = Full-Time protection. Option number 14 must be
enabled to allow Carjack functions to operate. See Operation : Carjack.
14. CARJACK FEATURES
This option controls the unit’s Car Jack features. Enable or Disable Carjack (Turn ON or OFF) with this option.
15. ARM/DISARM WITH IGNITION ON
This option controls whether the unit will allow arming and disarm using the remote when the ignition is on (or vehicle is running).
This program option may need to be enabled when using an Add-on remote starter to allow the alarm to be armed or disarmed
after remote engine starting. Note that you cannot use this feature if you are also using the Full-time carjack protection. If you
add a remote start and the Ignition turns on, a Carjack trigger will be activated.
16. Data Port Protocol:
This option controls the Data Port Protocol for 1-Way (OFA modules) or 2-Way (SL modules). The default is set for 2-Way
Protocol. This option has no effect on conventional wiring of Bypass modules.