Filter
Top Products
TRANSMITTER PROGRAMMING
This system will learn a maximum of 4 transmitters.
1. Turn Ignition ON/OFF…ON/OFF …ON. You should hear (3) chirps.
2. Press the Program/Override Button 5 times and you should hear 5 light flashes and 5 siren chirps.
(System is now in transmitter programming mode.)
3. Press and release Button #1 on the remote. The siren will chirp once. Press Button #1 AGAIN, you
should hear 2 chirps on the second press for code-learn confirmation. Sometimes it takes a 3
rd
press to
get the remote to learn.
4. Repeat step #3 for up to 3 additional transmitters, or turn Ignition OFF. Siren will chirp 3 times and lights
will flash 3 times when exiting the transmitter programming mode.
Note: If you are using CS-2002DC III identical alarms system in two vehicles, you can program button 4
(PANIC) from YOUR remote to ARM/DISARM the OTHER vehicle’s alarm. Follow steps above at the OTHER
vehicle, except press YOUR remote Button #4 (PANIC) 2 times in step #3 above. The other vehicle’s alarm
will learn YOUR Button #4 (PANIC). You can only ARM/DISARM the second vehicle. You cannot perform
any other special or auxiliary functions on car #2.
DIAGRAM:
IGN
OFF
TURN IGN. ON
3 TIMES:
ON, OFF
ON, OFF
ON.
5 CHIRPS
PRESS
BUTTON
5 TIMES
PRESS LOCK
BUTTON 2 X's
5 FLASHES
(CODE LEARNED)
IGN
OFF
LEARN
ANOTHER
REMOTE
OR
3 CHIRPS
1st = 1 CHIRP
2nd = 2 CHIRPS
PAN IC