Filter
Top Products
iLux
™
Integrated Lighting Systems w/infiNET
™
Installation Guide – DOC. 6416A iLux
™
Integrated Lighting Systems w/infiNET
™
: CLS-C6RF & CLS-C6MRF • 3
Check that any required Cresnet wiring has been installed
and verified. Then, use the following procedure to install
the iLux unit (CLS-C6MRF is shown in the illustrations).
1. Feed the wires (power line from the distribution
panel, load wires, plus any required Cresnet
cables) through the holes in the wallbox. Then
install the box in the wall.
2. Hold the rear of the CLS-C6MRF unit and remove
the front panel and cover assembly by carefully
pulling out and up from the bottom edge.
3. Remove the control panel overlay from the unit (it
lifts off – is held in place by small tabs) to reveal
the upper mounting screw holes.
4. Refer to the following diagram for connection of
the AC wiring. All wires to be inserted in the
screw terminals should be stripped 7/16-inch, and
screws should be tightened to between 8 and 10
in.-lbs. (0.90 Newton meters to 1.13 Newton
meters). The maximum wire size is 12 AWG.
5. Connect each load wire to the corresponding
LOAD terminals on the unit, connect the power
line hot wire from the circuit breaker to the HOT
terminal on the unit, connect all neutral wires to
the NEUTRAL terminal on the unit, and connect
all ground wires to the (ground) terminal on the
unit.
6. If Cresnet cabling is part of the installation, attach
the supplied terminal block connector to the
Cresnet cable and plug into the LOCAL
DEVICES port on the unit. Make certain that
there is a minimum 1/4-inch separation between
the Class 2 Cresnet wiring and the Class 1 AC
wiring.
7. Carefully tuck all wires into the wallbox and fasten
the unit to the wallbox using the four 7/8-inch
Phillips screws supplied.
8. Reattach the control panel overlay to the front
panel by inserting the four tabs into the slots
provided, and install the hinged front cover
assembly by lining it up at the top and pressing the
bottom edge until it snaps into position.