Creda NPP100 75-773002 Air Conditioner User Manual


 
Bathroom Installation
IMPORTANT – If the heater is installed in a room containing a bath or shower, it must be so installed that
switches and other controls cannot be touched by a person using a bath or shower.
Wall Mounting
IMPORTANT – DO NOT locate the heater immediately below a fixed socket outlet or connection box. The
wall bracket supplied with the appliance should be fitted using the screws and wall plugs provided. The
heater should be positioned observing the minimum clearances around the heater (see diagram C).
For all heater sizes
The bracket has been designed to be used as a template for setting the wall fixing position. Refer to the
diagrams below for dimensional details. To set the vertical minimum, the bracket should be positioned on
the floor and the wall marked at the notches in the vertical members of the bracket. This marks the final
position of the bottom of the bracket. When placing the heater on the bracket, firstly engage the heater on to
the bottom hooks and then press the heater on to the catches. It is recommended to press the heater at the
ends and not on the grille area.
500W Heater (refer to diagram A)
If the heater is required to be fitted towards an object/obstruction to the left then the bracket should be
positioned against the floor and the object/obstruction and the wall marked along the right edge of the right
upright. This is the final position of the left side of the left upright member of the bracket.
If the heater is required to be fitted towards an object/obstruction to the right then the bracket should be
positioned against the floor and the object/obstruction and the wall marked along the left edge of the left
upright. This is the final position of the right side of the right upright member of the bracket.
All other sizes of heaters (refer to diagram B)
If the heater is required to be fitted towards an object/obstruction to the left then the bracket should be
positioned against the floor and the object/obstruction and the wall marked at notch ‘A’. This is the final
position of the left side of the left upright member of the bracket.
If the heater is required to be fitted towards an object/obstruction to the right then the bracket should be
positioned against the floor and the object/obstruction, and the wall marked at notch ‘B’. This is the final
position of the right side of the right upright member of the bracket.
The bracket has also been designed to allow the use of a spirit level on the horizontal member for
levelling during fitting.
Final bracket position