Filter
Top Products
6
ASSEMBLY
ALWAYS use fresh cool water when operating the humidifier.
1. Turn Water Tank upside down and unscrew Water
Tank Cap.
2. Fill Water Tank with cool water. DO NOT fill water
all the way to the rim.
DO NOT CARRY FULL WATER TANK BY HANDLE.
ALWAYS HOLD WATER TANK WITH TWO HANDS.
DO NOT use hot water. Use cool tap water.
DO NOT add any medication, essential oils, or salt.
DO NOT pour water into Mist Outlet Channel.
3. Screw Water Tank Cap back onto Water Tank. Turn
the Water Tank over and place on Water Basin,
making sure it fits perfectly.
Note: Do not attempt to move the humidifier while
Water Tank is placed on the Water Basin. Doing so
may cause leakage of water and/or Water Basin to
overfill.
4. Plug the power cord into a wall socket and turn on the unit by using the Control
Knob.
5. The Power Indicator Light will illuminate in red. Within a few seconds, it will
switch to green, indicating that there is enough water in the Water Basin. Mist
will begin emitting through the Mist Lid.
6. Use the Control Knob to adjust the intensity of the mist output. It is best to have
the mist knob at a medium setting.
SET THE CORRECT HUMIDITY
OUTPUT: Adjust the Control Knob
so that the mist rises up to be
absorbed by the room air. Do not
set Control Knob too high, as the
mist cannot be absorbed by the air
and may accumulate on the
surfaces around the humidifier.
7. When the humidifier runs out of water, the Power Indicator Light will turn red and
the mist output will stop. This is a safety feature to prevent the humidifier from
possibly overheating and damaging the Nebulizer. Turn the humidifier off and
unplug the unit before removing and refilling the water tank.
Note: The Power Indicator Light on the humidifier will remain on. The
red light indicates that the humidifier is turned on and needs to be
refilled.
correct incorrect