Craftsman 390.262553 Water Pump User Manual


 
ELECTRICAL
Connection diagram for dual voltage, single-phase motors.
Your dual-voltage motor's terminal board (under the motor
end cover) will match one of the diagrams below. Follow
that diagram if necessary to convert motor to 115 Volt
power.
Connect power supply wires to L1 and L2. For 3-phase mo-
tors, or if motor does not match these pictures, follow the
connection diagram on the motor nameplate.
230 Volt to 115 Volt Conversion, Plug-inType:
1. Pull plug 2. Plug in again
straight with arrow
out from
on plug
terminal pointing to
board; '115 Volts'.
Clamp the power cable to prevent
strain on the terminal screws.
Connect the green (or bare copper) ground
wire to the green ground screw.
230 Volt to 115 Volt Conversion, Plug-in Type:
Move plug to change voltage.
V
,gPoinl
Power Supply Wires
Clamp the power cable to prevent
strain on the spade connectors.
Connect the green (or bare copper) ground
wire tothe green ground screw. 3782tooo
Figure 6 - I 15/230V Dual Voltage Single Phase Wiring Diagram.
[AWARNIN_Hazardous voltage. Can shock, burn, or
cause death. Disconnect power to motor before working on
pump or motor. Ground motor before connecting to power
supply.
WIRING
AGround motor before connecting to electrical
power supply. Failure to ground motor can cause
severe or fatal electrical shock hazard.
ADo not ground to a gas supply line.
A To avoid dangerous or fatal electrical shock, turn
OFF power to motor before working on electri-
cal connections.
A Supply voltage must be within +10% of name-
plate voltage. Incorrect voltage can cause fire or
damage motor and voids warranty. If in doubt consult
a licensed electrician.
A Use wire size specified in Wiring Chart (Page 6).
If possible, connect pump to a separate branch
circuit with no other appliances on it.
A Wire motor according to diagram on motor
nameplate. If nameplate diagram differs from
diagrams above, follow nameplate diagram.
1. Install, ground, wire and maintain this pump in accor-
dance with electrical code requirements. Consult your
local building inspector for information about codes.
2. Provide a correctly fused disconnect switch for protec-
tion while working on motor. Consult local or national
electrical codes for switch requirements.
5