Craftsman 139.53645SRT3 Garage Door Opener User Manual


 
Assemble the Door Arm:
Fasten the straight and curved door arm sections Door
together to the longest possible length (with a 2 or
3 hole overlap).
With the door closed, connect the straight door arm
section to the door bracket with the 5/16"x1-1/4" Cle_i,Pin
clevis pin. sit6.xt.t/4"
Secure with a ring fastener.
Straight
Arm
Ring
Lock
Washers
5/16"
Nuts
5/16"-18
Curved
Door Arm
On one-piece doors, before connecting the door arm to the trolley the travel limits must be adjusted. Limit adjustment
screws are located on the left side panel as shown on page 28. Follow adjustment procedures below.
Fully Closed
Trolley
Fully Open
Trolley
Door Arm Door Arm
m
I
, ...........
JL_ Closed
Door Open Door Door with
I
I Backward Slant
DoorArm
Connector Hole
Door Arm
Adjustment Procedures for One-Piece Doors
Open Door Adjustment:
Decrease UP limit
Turn the UP limit adjustment screw counter-
clockwise 5-1/2 turns.
Press the Door Control push bar or button. The
trolley will travel to the fully open position.
Manually raise the door to the open position
(parallel to the floor), and lift the door arm to the
trolley. The arm should touch the trolley just in
back of the door arm connector hole. Refer to the
fully open trolley/door arm positions in the
illustration, if the arm does not extend far enough,
adjust the limit further. One full turn equals 2" of
trolley travel.
Closed Door Adjustment:
Decrease DOWN limit
Turn the DOWN limitadjustment screw clockwise 5
complete turns.
Press the Door Control push bar or button. The
trolley will travel to the fully closed position.
Manually close the door and lift the door arm to the
trolley. The arm should touch the trolley just ahead
of the door arm connector hole. Refer to the fully
closed trolley/door arm positions in the illustration. If
the arm is behind the connector hole, adjust the limit
further. One full turn equals 2" of trolley travel.
Connect the door arm to the trolley.
Close the door and join the curved arm to the connector hole in the trolley with the remaining clevis pin. It may
be necessary to lift the door slightly to make the connection.
Secure with a ring fastener.
Run the opener through a complete travel cycle. If the door has a slight "backward" slant in full open position
as shown in the illustration, decrease the UP limit until the door isparallel to the floor.
27